After sharpening both sides of the blade place it on the kits cone-shaped balancer. If one side dips below the other continue sharpening it until the blade rests level. Return the sharpened blades to the mower and reattach. If you have a torque wrench its a good idea to use it here. Often you need to tighten the blade mounting bolt/bolts to a specific tightness level. Typically measured in pound-feet your instruction manual should list these specs. For example my personal machine the Honda HRR216VKA between 36 to 43 lb-ft of torque is required.
Other items and supplies include a plastic drip tray motor oil and a container for waste oil. Often a large piece of cardboard is useful as well an old rag or cloth. Also know that this guide deals with push or self-propelled mowers not riding mowers. While some advice here applies they are another animal altogether.
With the mower still on its side grab your socket wrench and wood block. Place the block inside the blade well. This is to prevent the blades from turning while you loosen their bolts. Remove the blade mounting bolt/bolts. A typical mower will have one blade like the Craftsman 37700 I serviced for this guide (one mounting bolt). Some like my Honda HRR216VKA have two blades an upper and a lower (two mounting bolts). Each blade should have at least two cutting edges.